Turbo Motor Inyección has a firm commitment to quality
100% of the components making up the repair Kit are always replaced using components of the same quality as the originals with regard to material, hardness, tolerances, etc.…
Likewise, approximately 90% of the remanufactured turbos are mounted with a new Turbine shaft and compressor wheel.
Turbo Motor has a metrology laboratory at its own facilities, to control the quality of all the components mounted. Whilst automotive-approved outside laboratories are used for the analysis of materials.
Each remanufactured turbo undergoes more than 30 different quality controls.
Our turbo balancing machines have been approved by the principal manufacturers of the original turbos.
The adjustment and control of the variable geometry is made on a test bench developed by Turbo Motor. The electronic controls performed on this bench ensure that 100% of the turbos manufactured comply with all the parameters.
All the turbos are marked with a serial number to guarantee the traceability of all their components.
The technical office employs seven mechanical engineers to control the product quality. In addition to an electronics engineer responsible for developing and studying the remanufacture of the new models equipped with an electronic servomotor.
Additionally, there are 3 technicians responsible for providing after-sales service to customers with regard to possible problems or doubts when mounting a turbo.